g240875
Figure 24
1.
Remove the drain plug
from the drain port.
3.
Loosen the air-vent plug.
2.
Remove the fill plug from
the fill port.
6.
Rock the cutting unit back and forth to ensure
complete drainage. When the oil is completely
drained, place the cutting unit on a level surface.
7.
Install the drain plug.
8.
Use a syringe (Part No. 137-0872) to fill the
drive box with 80-90W oil. Fill with 50 cc for
5-inch reels or 90 cc for 7-inch reels.
g240898
Figure 25
1.
Syringe with 80-90W oil
2.
Fill port
9.
Install the fill plug and tighten the air-vent plug.
10.
Torque all plugs to 3.62 to 4.75 N∙m (32 to 42
in-lb).
g241100
Figure 26
Right side groomer box shown
1.
Air-vent plug
3.
Drain plug
2.
Fill plug
Removing the Groomer
Drive Box
Note:
Retain all removed parts for later installation
unless otherwise stated.
Important:
If you have any issues removing the
groomer drive box, refer to your traction unit
Service Manual
or contact your authorized Toro
distributor.
1.
Remove the cap from the groomer.
2.
Remove the clamp bolts connecting the groomer
to the drive box (
).
3.
Remove the adjuster pin and cotter pin
connecting the groomer drive box to the adjuster
arms (
16
