Toro 07205TC Workman 3300-D, Operator'S Manual, Page: 47 / 56

47
MAINTENANCE
Figure 63
1. Tie rod
1
3. Rotate tie rod to move front of tire inward or
outward.
4. Tighten tie rod jam nuts when adjustment is
correct.
INSPECT CONSTANT VELOCITY BOOT
Four Wheel Drive Models Only
After every 200 operating hours, inspect constant
velocity boot for cracks, holes or a loose clamp.
FUSES
(Fig. 64)
There are 3 fuses in the machine's electrical system.
They are located under right side of dash panel.
FUSES
OPEN --
LIGHTS & HORN 10A
DASH 7.5A
IGNITION 7.5A
Figure 64
1. Fuse block
1
JUMP STARTING PROCEDURE
Jump starting can be dangerous. To avoid
personal injury or damage to electrical comĆ
ponents in vehicle, observe the following
warnings:
D Never jump start with a voltage sources
greater than 15 volts D.C. This will damĆ
age the electrical system.
D Never attempt to jump start a discharged
battery that is frozen. It could rupture or
explode during jump starting.
D Observe all battery warnings while jump
starting your vehicle.
D Be sure your vehicle is not touching the
jump start vehicle.
D Connecting cables to the wrong post
could result in personal injury and/or
damage to the electrical system.
WARNING
1. Loosen knobs securing battery cover to battery
base and slide cover off.
2. Connect a jumper cable between the positive
posts of the two batteries. The positive post may be
identified by a +" sign on top of battery cover.
Figure 65
1. Positive (+) cable
1
3. Connect one end of the other jumper cable to the
negative terminal of the battery in the other vehicle. The
negative terminal has NEG" on the battery cover. Do
not connect the other end of the the jumper cable to the
negative post of the discharged battery. Connect it to
the engine. Do not connect the jumper cable to the fuel
system.
4. Start the engine in the vehicle providing the jump
start. Let it run a few minutes, then start your engine.
5. Remove the negative jumper cable first from your
engine, then the battery in the other vehicle.
6. Reinstall battery cover to battery base and tighten
knobs.