Toro 07205TC Workman 3300-D, Operator'S Manual, Page: 22 / 56

!0*)-' 0!*% (Fig. 21) -Whenever the engine is shut
off, the parking brake must be engaged to prevent
accidental movement of the vehicle. To engage the
parking brake, pull back on lever. To disengage, push
lever forward. Make sure parking brake is released
before moving vehicle. If vehicle is parked on a steep
grade, make sure parking brake is applied. Also, shift
the transmission into 1st gear on a uphill grade or
reverse on a down hill grade. Place chocks at the down
hill side of wheels.
6$0!3+)# )&2 (Fig. 21) - Raises and lowers bed.
Move rearward to raise, forward to lower.
When lowering bed, hold lever in
forward position for 1 or 2 seconds after bed contacts
frame to secure it in lowered position.
(%- 0!)1)-' .0 +.5%0)-' "%$ .0 ),/+%7
,%-2 (6$0!3+)# .)+ 5)++ "6/!11 .4%0 ! 0%+)%&
4!+4% 5(%- #6+)-$%01 0%!#( 2(% %-$ .& 2(%)0
20!4%+ 12.//)-' /.5%0 !11)12 2. 12%%0)-'
'%!0 !-$ )-#0%!1)-' 12%%0)-' %&&.02 %7
+%!1% +)&2 +%4%01 2. ),,%$)!2%+6
!&2%0 "%$ .0 ),/+%,%-2 )1 0!)1%$ .0 +.57
%0%$ 2. 0%'!)- !11)12 2. /.5%0 12%%0)-'
. -.2 (.+$ 2(% (6$0!3+)# +)&2 )- %)2(%0
2(% 0!)1% .0 +.5%0 /.1)2).- &.0 ,.0% 2(!- 1%#.-$1
.-#% 2(% #6+)-$%01 (!4% 0%!#(%$ 2(% %-$ .& 2(%)0
20!4%+ (% (6$0!3+)# /3,/ ,!6 .4%0 (%!2 0%13+2)-'
)- /3,/ $!,!'%
6$0!3+)# )&2 .#*
(Fig. 21) - Locks lift lever so
hydraulic cylinders do not operate when vehicle is not
equipped with a bed.
!11%-'%0 !-$ .+$ (Fig. 21) - Left side of
passenger seat.
)'(.5 !-'% ()&2%0 (Fig. 21) - Adds three
additional speeds for precise speed control.
Vehicle must be completely stopped before
shifting between High and Low range.
Shift only on level ground.
Depress clutch pedal fully.
Move lever fully forward for High and fully
rearward for Low.
HIGH is for higher speed driving on level, dry surfaces
with light loads.
LOW is for low speed driving. Use this range when
greater than normal power or control is required. For
example, steep grades, difficult terrain, heavy loads,
slow speed but high engine speed (spraying).
There is a location between HIGH and LOW in
which the transaxle is in neither range. This should not
be used as a neutral position because the vehicle
could move unexpectedly if the HIGH-LOW shifter is
bumped and the gear shift lever is in gear.
)+2 2%%0)-' %4%0 (Fig. 22) - Lever on right side of
console allows steering wheel to be adjusted for
operator comfort.
..+!-2 %,/%0!230% !3'% (Fig. 22) - Registers
coolant temperature in engine. Operates only when
ignition switch is in On position.
.0- 322.- (Fig. 22) - Pressing button activates
horn.
)'30%
)+2 12%%0)-' +%4%0
'-)2).- 15)2#(
.0- "322.-
..+!-2 2%,/
'!3'%
-')-% +.5 .)+ /0%1130% +)'(2
(!0'% )-$)#!2.0
+.5 /+3' 15)2#(
+.5 /+3' )-$)#!2.0 +)'(2
-')-% .5 )+ 0%1130% )'(2 (Fig. 22) - Light glows
if engine oil pressure drops below a safe level while
engine is running. If light flickers or remains ON, stop
vehicle, turn off engine and check oil level. If oil level
was low, but adding oil does not cause light to go out
when engine is restarted, turn engine off immediately
and contact your local TORO distributor for
assistance.
. -.2 ./%0!2% 4%()#+% 3-2)+ 0%/!)0 )1
#.,/+%2% !)+30% 2. ."1%04% 2()1 /0%#!32).- ,!6
0%13+2 )- $!,!'% 2. 2(% %-')-%
+.5 +3' 5)2#( !-$ -$)#!2.0
(Fig. 22) Ċ Use to
preheat engine cylinders prior to cold engine starting
procedures Ċ cylinders are preheated automatically
during warm engine start operation. For cold starting,
push switch lever upward and hold while watching
indicator. Indicator will glow orange when the glow
plugs are activated. Length of time necessary to
preheat cylinders should be determined by
atmospheric temperature; refer to Starting /Stopping
Engine.