Toro 07205TC Workman 3300-D, Operator'S Manual, Page: 40 / 56

$#-*!
'#$'! $% $%,!*
Remove oil filter. Apply a light coat of clean oil to the
new filter seal before screwing it on. Screw filter on until
gasket contacts mounting plate, then tighten 1/2 to 2/3
of a turn. DO NOT OVER-TIGHTEN.
Add oil to crankcase, refer to Check Engine Oil.
$#
-!% $'!+ ' (''!,$('+
Check lines and connections every 400 hours or yearly,
whichever comes first. Inspect for deterioration,
damage, or loose connections.
-!% $%,!*,!* !)*,(*
Drain water or other contaminants from fuel filter/water
separator daily by loosening drain plug (Fig. 43) on
filter canister. Tighten plug after draining. Replace filter
canister after every 400 hours of operation.
Raise bed (if so equipped) and place safety
support on extended lift cylinder to hold up bed.
Fuel filter/water separator is mounted on inner side
of right frame rail (Fig. 42).
$#-*!
-!% "$%,!*.,!* +!)*,(*
-!% )-&)
Clean area around filter canister mounting surface.
$#-*!
*$' )%-#
$%,!* '$+,!*
Remove filter canister and clean mounting surface.
Lubricate gasket on filter canister with clean
engine oil.
Install filter canister by hand until gasket contacts
mounting surface, then rotate an additional 1/2 turn.
-!% -&) $%,!*
Remove and replace the filter after every 400 hours
operation.
Raise bed (if so equipped) and place safety
support on extended lift cylinder to hold up bed.
Fuel pump is mounted on inner side of right frame
rail (Fig. 42).
Thoroughly clean outside of assembly.
Place a drain pan under fuel pump and remove
cover from fuel pump (Fig. 44). Take care not to
damage wire while removing cover.
Pull filter out of pump body (Fig. 44).