g188311
Figure 10
Some fittings not shown
1.
Solenoid
7.
Adapter (1/4 inch male x
3/8 inch male)
2.
Solenoid valve
8.
Coupling (3/8 inch male x
3/8 inch female)
3.
Line body
9.
Elbow (3/8 inch male x 3/8
inch female), 90°
4.
Bonded seal (3/8 inch)
10.
Tee (3/8 inch male x 3/8
inch female x 3/8 inch
male)
5.
Adapter (3/8 inch male x
3/8 inch male)
11.
Lift manifold
6.
Check valve (3/8 inch)
18.
Connect the electrical leads from the electric control
box to the relevant solenoids.
1
2
3
4
5
6
7
5
1
6
2
7
3
8
4
8
9
10
G025362
11
12
g025362
Figure 11
1.
Right wing (labeled
2C
)
7.
Labeled
2F
2.
Middle (labeled
2B
)
8.
Cutter reverse rotation
(labeled
1
)
3.
Left wing (labeled
2A
)
9.
To the solenoid at the rear
of the machine
4.
Lift override (labeled
3
)
10.
To the proximity sensor
5.
Labeled
2D
11.
Lift control block
6.
Labeled
2E
12.
Electric control box
2
Installing the Rotary Valve
Cylinder Assembly
Parts needed for this procedure:
1
Actuator bracket
1
Proximity sensor
1
Proximity-sensor bracket
2
Setscrew (6 x 25 mm)
4
Washer (6 mm)
2
Locknut (6 mm)
2
Cap screw (5 x 20 mm)
4
Washer (5 mm)
2
Locknut (5 mm)
1
Spacer
1
Solenoid valve (closed)
1
Line body
2
Bonded seal (3/8 inch)
1
Adapter (1/4 inch female x 3/8 inch male)
1
Bonded seal (1/4 inch)
1
Hose (1/4 inch x 380 mm), 90° x straight
1
Tee (1/4 inch male x 1/4 inch male x 1/4 inch female)
1
Adapter (1/4 inch male x 1/4 inch male), 1.4 mm orifice
1
Cylinder rod spring pin
1
Bush
1
Washer (10 mm)
1
Valve cylinder
1
Bonded seal (3/4 inch)
1
Adapter (1/4 inch male x 3/4 inch male)
1
Swivel tee (1/4 inch female)
1
Adapter (1/4 inch male x 1/4 inch male), 0.8 mm orifice
1
Hose (1/4 inch x 2.156 m)
1
Adapter (1/4 inch male x 3/8 inch male)
1
Split pin
8
Cable tie
1
Hose tie (368 x 4.8 mm)
Procedure
1.
At the rear of the machine, remove the rear cover to
gain access to the rotary valve control system (
7
