tornos DECO 7/10, Manual

Page: 82 / 170

OPTIONS & ALLIED TOOLING − DECO 7/10 − DECO 7a/10a − DECO 7e/10e
300236 en − 02/07 Chap. 12.2 /2
12.1 TECHNICAL DESCRIPTION
Mounting of drilling / milling attachment:
as gang tooling in X1 / Y1;
as gang tooling in X2 / Y2 possible but incompatible with S2 drive
Number of attachments, max. 2
The toolholder for the spindle is located with two pins on the baseplate and
fastened with two Screws 110.
.
Caution !
Air service pressure must not sink under 6 bar.
The air pressure required for good operation of the spindle is 5 bar.
12.2 NSK SPINDLE
Fig. 1102
Operation and maintenance:
see the NSK NAKANISHI INC. supplier’s documentation, delivered with each
attachment.
Pneumatic drive: acc. to Diagram 305098 in Page 11/6
and Electrical Documentation 222 E 02 01
− Lubrication to be set at: 30 to 40 drops per minute
− The motor must not run without oil.
.
Caution !
Wait about 2 minutes before the oil reaches the spindle.
Checking: Disconnect at spindle level and wait till oil arrives.
Oil: acc. to the table below.
ENERGOL
HLP−D10
TELLUS
OIL C 10
VELOCITE
OIL No. 6
DTE 21
Mobil
MOTOREX
Pneumatics
Standard
COREX
EP D10
ISO 10
ISO−L−FD 10
BP