14
4
5
3
2
1
Tool Head
1. Lower the tool head.
2. Disconnect the vacuum hose.
3. Disconnect and remove the tool head.
A. Disconnect the solution hose.
B. Remove the two quick release tool pins.
C. Unscrew the two thumbscrews from each side of the tool head and slide the tool head off.
4. Remove the spray bar and rinse.
5. Visually inspect quick disconnect spray tips for blockage.
6. Open and clean the in-line strainer filter and replace.
• Disconnect the in-line strainer filter by using the quick disconnect coupler.
• Remove any debris from the strainer.
• Keep o-ring and threads of the plug lubricated.
DEFOAM is a good lubricant or use a non-petroleum based lubricant. This will ensure a tighter seal.
7. Remove any large debris from underneath the tool head. Rinse the vacuum chamber on the tool head.
8. Replace spray bar.
9. Connect the tool head.
• Connect the solution hose.
• Replace the two quick release tool pins.
• Replace the two thumbscrews from each side of the tool head.
10. Connect the vacuum hose.
11. Raise the tool head for storage.
1 Side Plate
2 Thumbscrew
3 Quick Release PIn
4 Inline Strainer Filter
5 Solution Hose
