INSTALL THE MOUNT ARM
9. Loosely secure the top of the mount arm to the enclosure with four M6 screws, four washers, and four nuts
using an M3 hex wrench.
Figure 3: Securing the top of the mount arm to the enclosure.
10. Using a level, align the bottom of the mount arm with the bottom of the enclosure.
Figure 4: Bottom of the mount arm level on the enclosure.
11. Using the bottom of the mount arm as a template, drill one hole using an electric drill and a 15/64 in. drill
bit.
12. Put one M6 screw, one washer, and one nut into the hole that you drilled in Step 11 using an M3 hex
wrench.
The mount arm is now secure enough to reliably drill the remaining three holes.
Page 6
©Tormach® 2021
Specifications subject to change without notice.
tormach.com
TD10715: Installation Guide: PathPilot Operator Console for 770 (0821A)