REASSEMBLE THE MACHINE
19. Connect the power cable to the Accessory Power port on the rear of the electrical cabinet.
20. From the ATC, remove and discard the existing USB cable. Then, route the loose end of the ATC USB
extension cable from the controller to the ATC, and connect it in place of the original USB cable.
21. If you have an EU model of the operator console, find the provided set of keys, and put it into the top of the
operator console.
Figure 24: Key put into the controller.
Note:
On EU machines, the keys switch between run mode and setup mode. If you don't have an
EU machine, you don't need the keys. For more information on operation modes, refer to the
Safety section of the EU machine operator's manual.
REASSEMBLE THE MACHINE
1. Put the right side window (that you set aside in "Prepare the Machine" (page 4)) back into the right side
panel on the enclosure. Then, tighten the screws on the vertical window retainers
2. Power on the machine and the PathPilot controller.
a. Turn the Main Disconnect switch to
ON
on the side of the electrical cabinet.
b. Twist out the machine's red Emergency Stop button, which enables movement to the machine axes and
the spindle.
c. Press the Reset button.
d. Bring the machine out of reset and reference it.
Page 17
©Tormach® 2021
Specifications subject to change without notice.
tormach.com
TD10715: Installation Guide: PathPilot Operator Console for 770 (0821A)