INSTALLATION
Install the Linear Rails
Complete the following steps in the order listed:
Assemble the Linear Rails
1. Find the four linear rails provided: use the two shorter linear rails on the right side of the enclosure. Use the
two longer linear rails on the left side of the enclosure.
2. Assemble each linear rail in the following order:
a. Slide one linear rail mount onto one end of the linear rail.
Don't completely tighten the clamping screw on the linear rail mount. It's easier to install and align the
linear rails with loose clamping screws.
b. Slide one bumper onto the linear rail.
c. Slide two linear bearings onto the linear rail.
d. Slide one bumper onto the opposite end of the linear rail.
e. Slide one linear rail mount onto the opposite end of the linear rail.
Make sure that the linear rail mount's clamping screw faces the same direction as the linear rail mount
that you installed in Step A.
Figure 19: Linear rail assembly.
3. Repeat Step 2 for the remaining three linear rails.
Install the Linear Assemblies
1. Align one short linear rail assembly to the two holes on the inside of both the right front panel and the front
lower panel.
The linear rail mount's clamping screws must face up.
Page 15
©Tormach® 2022
Specifications subject to change without notice.
tormach.com
TD10711: Installation Guide: 1100MX Enclosure Kit (0522A)
