Torklift A8002, Owner'S Manual

Page: 15 / 24

Page10
Deploying the GlowStep Revolution
To deploy the GlowStep Revolution, remove the 1/4" x 1-3/8" bail
pin in the left side release lever. Lift one of the levers, and begin to
pull the GlowStep assembly out. Pull from the top step to keep the
steps from angling up on their way out. Once past the locking detent,
release the lever. The locking mechanism is spring loaded and will
automatically lock the GlowSteps into the High position. Repeat this
process to move the step into the Medium position.
Once the GlowStep Revolution is in the Medium position, push the
steps back towards the GlowStep Revolution Frame to make sure
the locking mechanism is fully engaged.
Pull the bottom step away from the GlowStep Revolution Frame to
extend the steps, then place the All-Terrain Landing Gear feet on the
ground. If the steps need to be adjusted, begin by adjusting the upper
step at the GlowStep Revolution Frame into either the High or Low
position, then adjust the All Terrain Landing Gear. Once the step is
in the proper position, use the 1/4" x 1-3/8" Bail Pin to secure the left
side release lever. See
Figure 6.4.
The 1/4" x 1-3/8" Bail Pin MUST be installed before
using the steps.
Figure 6.4
1/4" x 1-3/8”
Bail Pin