Page8
Storing the GlowStep Revolution
To store the GlowStep Revolution, lift either step release lever, and
pull the GlowSteps out until the GlowStep Revolution frame is in
either the Medium or Low position. Lift the bottom step up until
roughly even with the top step. Push the bottom step towards the top
step, collapsing the GlowStep assembly.
Lift one of the step release levers, and, with the steps angled down,
push the GlowStep assembly up and into the GlowStep Revolution
Frame. It is best to push up from the bottom step.
In order to prevent damage, the
STEPS MUST BE FULLY
COLLAPSED
before being stored. Four, Five, and Six step units
have a shelf at the back of the GlowStep Revolution frame, which
will keep the steps from expanding when stored.
Guide the nylon studs (located on the second step from the top) into
the latches on either side of the GlowStep Revolution Frame. See
Figure 6.2
. Once the latches close around the nylon studs, the 1/4" x
1-3/8" Bail Pin can be installed in either handle to fully secure the
steps. See
Figure 6.3
.
The nylon studs will not fully engage the latches unless the steps are
completely collapsed.
WARNING:
Do
not
use or apply weight to the GlowStep Revolution
steps while in the stored position. Doing so may cause damage to the
guide studs.
Summary of Contents for A8002
Page 2: ......
Page 3: ......
Page 14: ...Page9 Handle Latch Nylon Stud Figure 6 2 Figure 6 3 1 4 x 1 3 8 Bail Pin...
