5
Step 3 – Option 2
In some cases the Power Armor battery box will fit between the two steel of
angles used to secure the stock battery box. If this is the case on your
trailer, refer back to Step 3 - Option 1.
If the Power Armor battery box is too wide to fit between the steel angles,
begin by drilling two 1/4” holes in each of the battery support straps. The
holes should be 15-1/2” apart. (see dimension “X” in figure 3.2)
Figure 3.2
Insert one
1/4"-20 x 2” Hex Bolt
with one
1/4" SS USS Flat Washer
down
through the slots of the
Angle Extension Bracket
and through each of the
holes previously drilled. The vertical flange on each
Angle Extension
Bracket
should be facing towards the outside of the trailer. Lightly secure
each bolt with one
1/4" SS USS Flat Washer
and one
1/4"-20 SS Thin
Nylock Nut
. Test fit to make sure the “
Angle Extension Mounting Holes
” in
the
Power Armor Battery Box
will align with the slots in the
Angle
Extension Brackets
. Adjust as necessary and tighten the
1/4"-20 x 2” Hex
Bolts
. See figure 3.3
X
Summary of Contents for A7720R
Page 8: ...7 Figure 3 4 ...
