2
Step 1:
Remove the
Power Armor Lid
by sliding the lid away from the side with
the lock, then lifting the front edge and unhooking the lid from the tabs on
the rear of the box.
The
Power Armor Battery Box
has slots cut into the
bottom of the box. Use a sharp knife to make an incision in the
Battery Mat
over each of the slots you plan to use for the battery strap.
Step 2:
On one side of the
Power Armor Battery Box
, insert the non-buckled end
of the
Battery Strap
down through the one of the slots you plan to use and
back up through the other slot (see figure 2.1 for slot locations.) Leave
approximately 10” of the buckled end inside of the box.
Battery Slots
Figure 2.1
Angle Extension Mounting Holes
Summary of Contents for A7720R
Page 8: ...7 Figure 3 4 ...
