Outdoor Dome Series | Quick Guide
14
Safety-cord screw
Safety-cord screw
1.
Tie your wiring into a junction box and feed the wiring through the bottom conduit hole on the
bottom case.
2.
Tighten the screws to secure the bottom case to the junction box. Then connect the wiring.
3.
Align the bottom case and the lens base, both of which have a red dot on the top side
respectively for aligning identification. Use the red dots to properly align them and then securely
fasten the 3 screws of the lens base to the bottom case with torx key (supplied).
4.
Adjust the focusing position by rotating and panning the camera lens base. Note that the side
conduit hole of bottom case is the point where the camera lens shouldn’t be rotated over.
5.
Fit the inner liner over the camera lens base until it snaps into the place.
6.
Mount the camera housing on the lens base, both of which similarly have a red dot for aligning
identification. Be aware that the red dot of camera housing is within interior instead of top side.
7.
Use the torx key (supplied) to tighten the 3 camera housing screws for mounting completion.
Note
Please properly lock the screw hole plug on side conduit hole while using the bottom
conduit hole for cable entry on junction box mounting method.
Keeping tilt angel over 17 degrees is recommended when IR-LED light is used. If tilt
angel is below 17 degrees from the horizontal, the image would be flashed by the
reflection of IR-LED light.
If you possess a safety wire (sold separately), connect the safety wire with one end to the mounting
surface and the other end to the safety-cord screw of the unit. Depending on different applications (flush
mount or surface mount), please connect the safety wire to the corresponding safety-cord screw as the
following figures illustrating.
Figure 2 - 8: Safety-cord screw for flush mount Figure 2 - 9: Safety-cord screw for surface mount
