TOPVERT L1 Series
E-
14
19: (Factory Reserved)
20: (Factory Reserved)
21: Accumulated power-up Day (day)
22: Accumulated power-up time (hh:mm)
23: (Factory Reserved)
24: (Factory Reserved)
25: (Factory Reserved)
26: The signal of AI1 analog input
27: (Factory Reserved)
28: (Factory Reserved)
29: (Factory Reserved)
30
~
33: (Factory Reserved)
34: Over-Torque detection level 1 (Pr5-16)
35: Motor 1 Auto torque boost (Pr5-01)
36~37: (Factory Reserved)
38: Stall level while run in constant torque area
(Pr5-12)
39
〜
52: (Factory Reserved)
53: Output power (kW)
54: Output capacity (kVA)
55
:
(Factory Reserved)
56: The temperature of IGBT module--TH1 ( °C)
57: The temperature of environment or fin (TH2)
(°C)
58: (Factory Reserved)
59: (Factory Reserved)
60: Drive overload accumulated time (OL)
61~63
:
(Factory Reserved)
64: DC Bus voltage upon a fault (Vdc)
65: Output voltage upon a fault (Vac)
66: Output frequency upon a fault (Hz)
67: IGBT module temperature upon a fault
( °C)
◎
68: Output current value upon a fault (Aac)
69
︰
Temperature of Fin or environment
upon a fault ( °C)
◎
70~86
︰
(Factory Reserved)
87: DC Bus ripple voltage (Vdc)
◎
88: (Factory Reserved)
◎
Pr0-08
User-Defined coefficient
K
0
~
39 (no use)
0
40
~
60000 (the corresponding value for Pr1-00-- the
max. frequency).
Pr0-09
The decimal places
0~3 (0=Without d.p., 1= 1 digit d.p., 2=2 digit d.p.,
3=3 digit d.p.)
0
Pr0-10
Firmware version
Read-only
x.xx
Pr0-11
EPROM store set
Bit 0
(bxxxx0)
0: FWD/REV direction command will be
store
b00000
1: FWD/REV direction command not
store
Bit 1
(bxxx0x)
0: Frequency command from PU will be
store
1: Frequency command from PU not
store
Bit 2
(bxx0xx)
0: RS-485 frequency command will be
store
1: RS-485 frequency command not store
Bit 3
(bx0xxx)
0: Up/Down frequency command will be
store
1: Up/Down frequency command not
store
Summary of Contents for TOPVERT L1 Series
Page 33: ...TOPVERT L1Series E 32...
Page 34: ...TOPVERT L1Series E 33...
Page 35: ...TOPVERT L1Series E 34...
Page 66: ...TOPVERT L1 C 31...