Topper 20-209-001, Installation & User Manual, Page: 38 / 48

38
Sanitize Water on Water
This can be performed at the time of the filter replacement.
Place a towel down under the system for spills. Also have a small bucket available.
1. With feed supply on, drain down about 60 seconds of water through the faucet, then
close the faucet.
2. Giving it 10 seconds, the system should be de - pressurized by this time. The “ PW/SQ ”
ports will not have any pressure.
3. Turn off supply to the “ F ” port.
4. Remove the “ PW ” and the “ SQ ” pins.
5. Install the Sanitizer Cannister (available online at www.wowwater.com) to the “ PW ” port,
using a ¼ ” tube, making sure the cannister has the sanitizing solution (3% Hydrogen Per-
oxide) inside. (This is important).
6. Place ¼ ” tubing in the “ SQ ” port and direct the “ SQ ” exit into a bucket or pot.
7. Using the supply line to pressurize the sanitizer is best, so detach from the “ F ” port. Place
into the sani - cup and turn on the supply for 10 seconds.
8. You are now ready to turn on the feed valve to the sanitizer. Water will immediately em-
anate from the
“ SQ ” port into the bucket. Leave it on for about a liter/quart of water.
You have now introduced a sanitizer to the product water bladder.
9. Next, remove sanitizer tube from the “ PW ” port. Disengage the Feed Line from the Sani-
tizer Unit and place back into the “ F ” port. Plug in the “ PW ” port. Remove the “ SQ ” ex-
haust line and place the plug back in the “ SQ ” port.
10. Leave the Sanitizing Solution in the system for about 2 hours, then open the faucet and
drain the system until empty. Then let the system fill on its own.