Topper 20-209-001, Installation & User Manual, Page: 24 / 48

24
Adding a Cooler
Water Cooler Hook - ups: (Figure 8A, Page 23)
Adding a line from the WOW RO System to a cooler will ensure the RO water
is always being used to create great tasting water. When adding devices with
larger storage capacities, like coolers, you must first determine draw down
needs.
Refer to Section 2, Page 16 - 17, “ Determining your Expansion Needs ”.
Adding a cooler to a new WOW (dry) installation:
a. Use FA1 or FA2.
b. Connect FA1 or FA2 plastic tubing to the cooler.
c. Make sure that a 3/8” or 1/4” isolation/shut - off valve is installed at the system in
the cooler line and easily accessible under the sink cabinet (Figure 6).
d. Close the Isolation Valve.
e. Go to Start - up Procedures (Page 15) and proceed until fully operational.
f. When system is full after conditioning, open the isolation valve and bleed the line to the cool-
er.
Adding a cooler to a pre - installed WOW (wet) installation:
a. Close the Primary Shut - Off Valve.
b. Open the faucet to relieve pressure on the FA ports.
c. Remove the 3/8” plug from the FA1 port by pushing on the white collet, releasing the plug.
d. Connect the 3/8” plastic tubing to the FA1 port that goes to the cooler.
e. Make sure that a 3/8” isolation/shut - off valve is installed at the system in the cooler line and
easily accessible under the sink cabinet (Figure 6).
f. Close the Isolation valve.
g. Turn on the Primary Shut - Off Valve.
h. Open the Isolation Valve.
i. Bleed the line to the cooler as described below (Bleeding Lines).
Bleeding Lines:
Open the Spigot to dispense water and wait for a solid stream
of water.
Gravity Cooler
Pressurized Cooler
Figure 6
Isolation Valve