Topper 20-209-001, Installation & User Manual, Page: 17 / 48

17
Place the WOWRO 50 System upside down to locate the 3 tank base fastener holes. Place leak
base onto the tank base and align with the fasteners holes. Using the phillips head screws sup-
plied. Attach all of the screws to their stop point. DO NOT OVER
- TIGHTEN ! Do same for 180 kit.
Attaching Leak Detection System 50
Turn system right side up. The 180 tray comes pre - plumbed. For the short tray, plumbing needs
to be assembled. Attached one end of the short tube to the regulator. Push in to a complete stop
(double check). Attach the other end of the short tube to the
“ IN ” port of the leak detector.
Attach one end of the long tube to the RF Port. Attach the other end of the long tube to the
“ OUT ” port of the leak detector. Push in to a complete stop (double check).
This completes the Leak Tray addon.
OFF
Starting the WOWRO 50 with the Leak Detection
Go to the Installation Manual and follow directions on pages 13, 14, 15.
NOTE:
Your system now has an added shut - off switch. To start the system, all feed valves need to be
in the on position, including the Leak Switch.
ON
Step 2
Step 3