3.3
INSTALLING THE ADAPTER AND RAIL
Door panel
Adapter
-Drill the door at the bottom and fasten the rail
using flared self-tapping cylindrical screws
diam. 4.8.
-Make sure the upper part of the panel
crossbar is reinforced at the base (minimum
thickness 3 mm);
-Cut the adapter and rail to the measurement
of the finished door width, removing another 2
mm from the jamb sider;
-Drill the adapter and rail starting at about
70/80 mm from the end;
@
The number of fastening holes will depend
on the size and weight of the door.
-Mark the fastening points on the door using
the adapter and rail as a templat;
-Drill the door panel at the top and fasten the
adapter using cylindrical M6 screws or
c y l i n d r i c a l s e l f - t a p p i n g d 5 . 5 s c r e w s
depending on the type of material;
Rail
IRON
4 mm (with lesser thickness use threaded rivets)
6 mm (with lesser thickness use threaded rivets)
100 mm
50 mm
Minimum thickness
Materials of the fastening surface
ALUMINUM
SOLID WOOD
REINFORCED CONCRETE
110 mm (with lesser thickness use chemical bolts)
PERFORATED CONCRETE
70÷80
40
40
45
Fig.
7
20
31
Wheel glide
profile
finely ribbed profile
(200mm profile for
each 200mm cross bar)
cross bar
Fig.
6
finely ribbed
profile
cross bar
Wheel glide
profile
11
INSTRUCTIONS FOR INSTALLATION AND USE
EN
K500