THE MAINS TO WHICH THE ACTUATOR IS CONNECTED MUST COMPLY WITH THE
REQUIREMENTS OF THE LAWS IN FORCE IN THE COUNTRY OF INSTALLATION, AS
WELL AS SATISFY THE TECHNICAL FEATURES GIVEN IN TAB. 1 AND ON THE
RATING PLATE AND THE "CE" MARKING (PAR. 3.1).
THE SECTION OF THE MAINS CABLES MUST BE PROPERLY SIZED ACCORDING TO
THE ABSORBED ELECTRIC POWER (SEE RATING PLATE AND "CE" MARKING).
ANY TYPE OF ELECTRIC MATERIAL (PLUG, CABLE, TERMINALS, ETC.) USED FOR
THE CONNECTION MUST BE SUITABLE FOR THE USE, WITH "CE" MARKING AND
COMPLYING WITH THE REQUIREMENTS FORESEEN BY THE LAWS IN FORCE IN
THE COUNTRY OF INSTALLATION.
TO ASSURE A CORRECT SEPARATION FROM THE MAINS, IT IS COMPULSORY TO
INSTALL UPSTREAM OF THE DEVICE A BIPOLAR TEMPORARY SWITCH (PUSH-
BUTTON) OF APPROVED TYPE. UPSTREAM OF THE CONTROL LINE, IT IS
COMPULSORY TO INSTALL AN UNIPOLAR CUTOUT SWITCH WITH CONTACT
OPENING OF AT LEAST 3 mm.
BEFORE PERFORMING THE ELECTRIC CONNECTION OF THE ACTUATOR, VERIFY
THAT THE POWER SUPPLY CABLE IS NOT DAMAGED. SHOULD IT BE DAMAGED, IT
MUST BE REPLACED BY THE MANUFACTURER OR BY THE TECHNICAL
ASSISTANCE SERVICE OR IN ANY CASE BY AUTHORIZED OPERATORS.
5.5- CONTROL DEVICES
THE CONTROL DEVICES USED TO DRIVE THE ACTUATOR MUST ASSURE THE
SAFETY CONDITIONS FORESEEN BY THE LAWS IN FORCE IN THE COUNTRY OF
USE.
According to the different type of installations, the actuators can be driven by the
following control devices:
1) MANUAL PUSH-BUTTON:
Bipolar switch button with central OFF position, with biased-off switch;
2) OPTIONAL: CONTROL AND FEEDING UNIT:
TOPP
Microprocessor control units
(e.g.: Mod. TF44, etc.)
controlling the single
actuator
(C30S/230V)
or more than one actuator simultaneously
(C30S/230V)
or by
means of one or more manual pushbuttons, an infrared remote control or a 433 Mhz
radio control.
The electrical connection of the
C30S/24V
version must be made with a 24V power
supply / control units of appropriate power.
To these control units, it is possible to connect the rain sensors
(RDC -12V)
, the
windsensor
(RW)
and the brightness sensor;
21
C30S
INSTALLATION -5
INSTALLATION AND USE ISTRUCTIONS
