WOOD CHIPPER
16
GB
S u d d e n s t o p p i n g a t a h i g h
speed under a heavy load is not
recommended. Engine damage may
result.
Do not move the choke control to
CLOSE to stop the engine. Backfire
or engine damage may occur.
Move the throttle lever to the SLOW (
)
position.
Let the engine idle for one or two minutes.
Turn the engine switch to the OFF position.
Turn the fuel valve lever to the OFF (
)
position.
1.
2.
3.
4.
Wood Chipper Operation
The engine is shipped without oil.
Do not start the engine before
adding oil.
Operating
After the engine warms up, pull the throttle
lever to accelerate engine speed.
As the engine is increased slowly to full speed,
gradually and slowly pull the belt tension lever
as far as it will go to engage the belt drive. This
has to be done slowly to allow the cutting disk
to pick up speed, otherwise the engine will stall
because there is high inertia in the cutting disk.
The chipper shredder can process a wide
variety of dry or green organic materials such
as branches, stalks, vines, leaves, roots, and
Start the Engine
Using the same way as the dumper engine to
start the chipper engine.
Feed limbs or branches through cut-end first,
leaving the bushy head on. This helps guide
the limb down the feed hopper and reduces
spinning and bouncing of small pieces back
up the feed hopper. Some side branches may
require pre-cutting so that the branch will self-
feed more efficiently.
It is always advisable to process freshly cut
materials, as wooden branches get very hard,
they become springy when dried out and can
make the knives dull more quickly.
While operating the machine, keep a wooden
stick handy, approximately 1 inch in diameter
by 2 feet long. This stick will be useful to push
in short, brushy and very leafy materials and
keep the feed hopper clear.
Do not force material into the machine. If it
does not chip well, the chipper knives may
need sharpening or to be replaced, or the gap
between the knives and the wear plate needs
adjusting .
Do not overload the machine by feeding too
much material in to the feed hopper at one time.
If you hear the speed of the engine decreasing,
immediately stop feeding material in to the
machine. Do not resume feeding material into
NO HANDS BELOW THIS LINE
STOP ENGINE
To stop the engine in an emergency, simply turn
the engine switch to the OFF position. Under
normal conditions, use the following procedure:
vegetable matter. The maximum capacity
is 3-inch diameter branches, this can vary
depending on the type and hardness of wood.
Rotating the branch as you feed it into the
machine will improve performance.
36087UK00M100-出货版_更新回收处理标志.indd 16
2019/10/22 16:18:02