WOOD CHIPPER
23
GB
If the machine’s cutting disk strikes a foreign
object, or if the machine begins to make
an unusual noise or vibrates excessively,
immediately shut off the engine. Allow the
cutting disk to come to a complete stop. Switch
the engine to “off” to avoid any accidental start.
Then perform the following steps:
●
Inspect for damage.
●
Repair or replace damaged parts.
●
Check for any loose parts and tighten to
ensure continued safe operation.
●
If the cutting disc gets stuck by branches,
open the bearing cover, then turn the disc
shaft using wrench in order to rotate the
disc.
Knife And Wear Plate Inspection
Routine inspection of the knives for sharpness
and wear plate for a sharp edge will ensure
that your chipper shredder is operating at
full efficiency. Using dull knives or a rounded
wear plate will decrease performance and
cause excessive vibration that will damage the
machine and make chipping difficult for the
operator.
M10
(
×
2)
Knife Removal and Replacement
This chipper shredder is equipped with two
chipper knives mounted on the cutting disk.
When the knives get dull or show visible nicks,
the machine will lose its self- feeding action
and the material has to be pushed in. Often
it comes out in long strips. The knife is case-
hardened and reversible. Normally the edges
will last for a long time. When the edge is
rounded off, it can be reversed. When both
edges are worn, the knifes should be replaced.
Replace the knifes by following steps.
1.
Remove the two M8 nuts, then open the
feed hopper.
2. Remove the bolts that fix the blade.
Be careful and wear gloves when
working near the knives.
1
2
3.
Remove the dull or damaged knives and
visually inspect the cutting disk slot and
knives mounting area. Make sure they are
clean and that there placement knives will
be able to mount flush against the cutting
disk. Remount new or sharpened knives
with the knife edges facing up.
36087UK00M100-出货版_更新回收处理标志.indd 23
2019/10/22 16:18:29