POWERED WHEELBARROW
14
GB
Rapid retraction of the starter cord
(kickback) will pull your handand arm
toward the engine faster than you
can let go. Broken bones, fractures,
bruises, or sprains could result.
SLOW
FAST
OPEN
CLOSED
Operating
After engine warms up, pull throttle lever to
accelerate engine speed.
The powered wheelbarrow has the steering
levers on the handlebars and this makes
steering very easy. To turn right or left,
simply operate the corresponding right or left
steering lever.
The sensitivity of the steering increases in
proportion to the speed of the machine and
that with the empty machine, a light pressure
on the lever is all that is needed to turn. While
when the machine is loaded, more pressure is
required.
The powered wheelbarrow has a maximum
capacity of 300kg. However, it is advisable to
assess the load and adjust it according to the
ground on which the machine will be used.
It is therefore advisable to cover such
stretches using low gear and taking extra care.
In such situations, the machine should be kept
in low gear for the whole stretch.
Avoid sharp turns and frequent changes
of direction while driving on the road, in
particularly on rough, hard terrains full of
sharp, uneven points with a high degree of
friction.
Remember to be careful when working in
adverse weather conditions (ice, heavy rain
and snow) oron types of ground that could
make the powered wheelbarrow unstable.
When the clutch control lever is released, the
machine will stop and brake automatically.
If the machine is stopped on a steep slope, a
wedge should be placed against one of the
wheels.
Idle Speed
Set the throttle control lever to the SLOW
position to reduce stress on the engine when
work is not being performed. Lowering the
engine speed will help extend the life of the
engine, as well as conserve fuel and reduce
noise level.
STOP ENGINE
To stop the engine in an emergency, simply
turn the engine switch to the OFF position.
Under normal conditions, use the following
procedure:
Move the throttle
lever slightly to the
FAST speed.
Pull the recoil starter until the engine starts.
Return the recoil to the home position after
each pull. Repeat the steps as needed. Once
engine has started, set the throttle to the
FAST position before you operate the unit.
Move the throttle lever to the SLOW (
)
position.
Let the engine idle for one or two minutes.
Turn the engine switch to the OFF position.
Turn the fuel valve lever to the OFF (
)
position.
4.
5.
1.
2.
3.
4.
S u d d e n s t o p p i n g a t a h i g h
speed under a heavy load is not
recommended. Engine damage may
result.
Do not move the choke control to
CLOSE to stop the engine. Backfire
or engine damage may occur.
09618UK00M102_不带档位板-出货版.indd 14
2020/6/10 15:40:56
