POWERED WHEELBARROW
15
GB
MAINTENANCE
Never use a “pressure washer” to
clean your unit. Water can penetrate
tight areas of the machine and its
transmission case and cause damage
to spindles, gears, bearings, or the
engine. The use of pressure washers
will result in shortened life and
reduce serviceability.
1.
2.
3.
4.
5.
Maintaining your mini powered wheelbarrow
will ensure long life to the machine and its
components.
Preventive Maintenance
Turn off the engine and disengage all
command levers. The engine must be cool.
Keep the engine’s throttle lever in its SLOW
position and remove the spark plug wire
from the spark plug and secure.
Inspect the general condition of the power
trackbarrow. Check for loose screws,
misalignment or binding of moving parts,
cracked or broken parts, and any other
condition that may affect its safe operation.
Use a soft brush, vacuum or compressed
air to remove all contaminants from the
machine. Then use high quality light oil to
lubricate all moving parts.
Check the spark plug wire regularly for
signs of wear, and replace when needed.
Adjusting clutch
As clutch wears out, the same lever could
have a wider opening, being so uneasy to
use. This means that it is necessary to adjust
the cable, setting clutch lever on its original
position acting on the adjustment device and
on counter-nut.
Adjusting steering
If you have difficulty steering the unit, you will
need to adjust the steering levers with the
special adjusters. Slacken off the locknut and
unscrew the adjusters to eliminate the play in
the cable, which can occur after initial use or
normal wear. Be very careful not to unscrew
the adjusters too much because this can
create another problem: the loss of traction.
Remember to tighten the locknut when you
have finished.
Lubrication
The gearbox is pre-lubricated and sealed at
the factory.
Check oil level every 50 hours of working.
Remove the plug and check, with machine
horizontal, oil reaches the two notches. If
necessary, add the oil.
G e a r o i l G L - 5 o r G L - 6 , S A E 8 0 W - 9 0 i s
recommended. Do not use synthetic oil.
Oil must be replaced when hot by unscrewing
filler cap and plug equipped with an oil
dipstick. When oil is completely drained,
replace filler cap and fill up with new oil.
Tire Pressure
Check the pressure of tires periodically to make
sure they are properly inflated.Recommended
pressure is 30psi for all the tires.
Separation of tire and rim parts is
possible when they are serviced
incorrectly.
Do not attempt to mount a tire
without the proper equipment and
experience to perform the job.
Do not inflate the ties above the
recommended pressure.
Do not weld or heat a wheel and tire
assembly. Welding can structurally
w e a k e n o r d e f o r m t h e w h e e l .
Heating can cause an increase in the
air pressure resulting in burst.
Do not stand in front or over the tire
assembly while inflatig.
Engine Maintenance
Refer to the Engine Manual included in
your unit for the information on engine
maintenance. Your engine manual provides
detailed information and a maintenance
schedule for performing the tasks.
09618UK00M102_不带档位板-出货版.indd 15
2020/6/10 15:40:56
