Topens MT9012, User Manual

Page: 20 / 32

17
the button (open-stop-close-stop-open).
Exit Wand (optional)
Please note that the adapter board of the exit wand should be inserted into the main control board of
the gate opener before using.
The
BLACK
and the
BLUE
wire of the exit wand should be connected into the “LOOP” terminal, no matter the
polarity.
The
RED wire of the exit wand should be connected into the COM (9#) terminal.
The GREEN wire of the exit wand should be connected into the BAT- (14#) terminal.
The sensitivity adjustment board should be wired to the GREEN wire and the YELLOW wire of the wand. No
matter the polarity.
Electric Lock (optional)
The electric lock should be wired to the “LOCK” terminal, no matter the polarity of the wires. The E-Plus board
is not needed to use with this model of gate opener. Please remove the board from the lock before using.
External Receiver (optional)
The BROWN wire of the external receiver should be connected into the “19” terminal.
The BLACK wire of the external receiver should be connected into the “20” terminal.
The RED wire of the external receiver should be connected into the “9” terminal.
Wired Keypad (24VDC) (optional)
The RED wire of the wired keypad should be connected into the “9” terminal.
The BLACK wire of the wired keypad should be connected into the “14” terminal.
The PURPLE wire of the wired keypad should be connected into the “19” terminal.
The
BLUE
wire of the wired keypad should be connected into the “20” terminal.
How to Program or Erase the Remote

The remote MUST be programed to the opener BEFORE OPERATING. Please follow the steps to
program the remote.

Activate the opener only when gate is in full view, free of obstruction and properly adjusted. No one
should enter or leave gate area while gate is in motion. DO NOT ALLOW CHILDREN to operate push
button or remote. DO NOT ALLOW CHILDREN TO PLAY NEAR THE GATE.

If you purchase additional remote controls, the gate opener must be programmed to accept the new
remote code.

If you lose one of any remote control, please erase and reprogram all other remote controls to have a
new code for safety.