26
Mode switch control
Laser mode is switched alternately as follows.
Scan mode / Level sensor mode / Laser pointing mode.
If this key is pressed in other modes except Scan, Laser sensor and Laser pointing
modes, the mode will change to scan mode.
X/Y axis selection
Vertical :
Setting line control
Horizontal :
Setting slope
Sets line control mode by pressing the key for more than three seconds. Then X axis
lamp will light.
Sets slope mode by pressing the key for more than three seconds. Then X axis lamp
will light. Lightly pressing this key for short time will switchover the X and Y axis.
Press the alignment key when in the above rotation (vertical, horizontal), only then
will the rotating laser switch to the line control mode or the slope mode.
To cancel the line control mode or the slope mode, press this key for more than three
seconds.
When this key is pressed under the interference condition (several RC-40s or RL-
VH4DR/G2 are using the same channel), the X/Y axis red lamp will flash.
When you find it difficult to operate the remote controller, use it away from the ground.
(Radio transmission performance is lower near the ground.)
With the RC-40, both the X and Y axes lamps will flash red simultaneously
when more than one RC-40 or RL-VH4DR/G2 are used, and also when similar
wireless signals (wireless LAN, etc.) are being transmitted.
Summary of Contents for RL-VH4DR/G2
Page 1: ...INSTRUCTION MANUAL ROTATING LASER RL VH4DR G2 31375 90050 TEP...
Page 2: ...EU...
Page 47: ...45...
