Net-G3A Configuration and Setup
NET-G3A Operator’s Manual
3-10
• Shows the status of post-processing mode (static or dynamic)
when performing a Post-Processing Kinematic survey with the
help of the FN key (REC LED).
• Shows the power status for the receiver (PWR LEDs).
Use PC-CDU to configure MINTER settings. The procedure below
describes the most common settings; refer to the
PC-CDU Reference
Manual
for other possible MINTER configurations.
1. Connect your receiver and computer. See “Connecting the
Receiver and a Computer” on page 2-15 for this procedure.
2. On the
Connection Parameters
dialog box, enable RTS/CTS
handshaking (Figure 3-9).
See “PC-CDU Connection Parameters” on page 2-22 for details
on setting other parameters.
3. Click
Connect
.
Figure 3-9. Connection Parameters – MINTER Settings
4. Click
Configuration
Receiver,
and then click the
MINTER
tab. Set the following parameters, and click
Apply
See the following pages for parameter descriptions:
•
Recording interval
on page 3-11
•
Elevation mask for log file
on page 3-11
•
File name prefix
on page 3-11
NOTICE
Clearing the receiver’s Non Volatile Random
Access Memory (NVRAM) will return all settings
made using PC-CDU to the factory default settings.
Net-G3A_OM_Book.book Page 10 Thursday, May 14, 2009 8:49 AM
