Topcom BUTLER E600 TWIN, User Manual

Page: 30 / 188

30
Reset the phone
9 Reset the phone
It is possible to return the phone to the original default configuration. This is the configuration which
was installed when you first received the telephone. After the reset all your personal settings and
call list entreis will be deleted, but you phonebook remains.
To return to default settings:
10 Troubleshooting
1
Enter the menu by pressing the left menu key.
2
Select “
DEFAULT
” and confirm.
3
Enter the 4-digit system PIN and confirm.
4
Confirm again.
Symptom Possible cause Solution
No display Batteries uncharged Check the position of the batteries
Recharge the batteries
Handset turned off Turn on the handset
No tone Telephone cord badly connected Check the telephone cord
connection
The line is occupied by another
handset Wait until the other handset hangs
up
The icon flashes Handset out of range Bring the handset closer to the base
The base has no power supply Check the mains connection to the
base
The handset is not registered on
the base Register the handset on the base
Base or handset do not
ring The ringing volume is off or low Adjust the ringing volume
Not possible to transfer a
call on PABX The flash time is too short or too
long Change the flash time
Telephone does not react
when pressing the keys Manipulation error Remove the batteries and put them
back in place