Example:
In the interface,
n001 Lin M File:1144
n002 Outp File:1144
press Del 1Row once, then the line becomes
n001 Outp File: 1144
(The instruction in the old n001 line is deleted.)
Modify
Modify
Modify
Modify program:
program:
program:
program:
In the Ed Prog(Edit program)state, according to the open file, find the line
number need to be modified through the PgUp or PgDn key on the controller panel,
and find the required instruction through the F1 or F2 on the controller panel left side
corresponding to PgUpInst(Page up instruction) or PgDnInst(Page down instruction).
Then through the ‘↑’‘↓’key on the controller panel, move the cursor and modify the
parameter in the cursor position. After modifying the current line, if continue to
modify, once again find the line number need to be modified through the PgUp or
PgDn key,and modify the program by the above method. if not modify, press Exit to
return to the Sv Prog(Save program) in the ProgMgmt(Program Management)
interface, and save the file according to the prompt of Sv Prog(Save program).
Newly
Newly
Newly
Newly build
build
build
build program:
program:
program:
program:
In the Ed Prog(Edit program)state, after the F key on the controller panel is
pressed for three seconds, the interface will clear the previous open file and re-create
a new file. At this time, the program current line is n001, the instruction is End, and