34
❏
7.
Remo
v
e
the tubes from the fuselage
.
T
ap 4-40
threads through the holes y
ou just dr
illed.
Use a fi
le
to
remo
v
e
an
y b
u
rrs from the tapped holes
. Remount the
panels to the fuselage with 4-40 x 1" [25mm] SHCS
and a drop of threadloc
k
e
r in each tube
.
MOUNT
THE OUTBO
ARD
WING P
A
NELS
❏
1.
Deter
mine which molded plastic oil cooler air
scoop is the r
ight and which one is the left b
y
test
fi
tting them to the outboard wing panels
. Hold the
left air scoop to the left outboard wing panel.
Use a
fi
ne-point f
e
lt-tip pen to mar
k the outline of the scoop
directly onto the wing.
❏
2.
Cut the co
v
e
ri
ng from the wing 1/16" [2mm]
inside the lines y
ou mar
k
e
d, b
u
t lea
v
e the b
lac
k
co
v
e
ri
ng in place
. Wipe a
w
a
y
the ink with one of y
our
small paper to
w
e
l squares and denatured alcohol.
❏
3.
Glue the air scoop to the wing with medium CA.
❏
4.
Mount the r
ight air scoop to the r
ight wing panel
the same w
a
y.
❏
5.
Fit the end of one of the 10 x 150mm alumin
u
m
outer panel wing tubes that has the threaded hole into
the left, inboard wing panel.
Secure the tube in the wing
with a 4-40 x 3/4" [19mm] SHCS
. Also fi
t one of the 22
x 295mm outer panel wing tubes into the panel.
❏
6.
Join the outboard panel to the inboard panel
with a 1/4-20 x 2" [50mm] n
y
lon bolt.
Tighten the
outboard panel to the inboard panel
❏
7.
The same as w
as done f
o
r the inboard panels
,
dr
ill a #43 hole through the end of the tube in the
outboard panel.
❏
8.
Remo
v
e
the outboard panel and the tube
.
T
ap
4-40 threads into the hole y
ou dr
illed in the tube
. File
off an
y b
u
rrs from the holes
.
