Toolla TM 76010, Instruction Manual

Page: 11 / 13

TM 76010 English
www.toolland.eu 11

Fix the cutter by fastening the bolts,
opposed to the direction as shown.

To replace the other cutter, rotate the
cylinder 180° and repeat the steps
described above.

Always unplug the tool before replacing
the cutters.
Adjusting a cutter

Set the planning depth to 0.

Turn the screws in or out to determine
the correct adjustment. The cutter is
properly adjusted when the cutting edge
touches the surface of the work piece.
Setting the planning depth

Turn the adjustment knob until the
desired planning depth is reached.

The depth setting can be read from the
scale.
Mounting and setting the parallel fence

The parallel fence is used for planning
along edges.

Loosen the fixing screw.

Hold the parallel fence right across its
width against the side of the machine.

The groove should engage in the bracket.

Insert the mounting screw from the
opposite side of the machine into the
mounting hole and turn it into the
bracket.

Securely tighten the mounting screw.

Tighten the fixing screw.

To set the parallel fence, proceed as
follows.

Loosen the set screw.

Set the parallel fence to the required
distance.

Tighten the set screw.
USE
Switching on and off

To switch the tool on, keep the lock-off
button depressed and press the on/off
switch.

To switch the tool off, release the on/off
switch.
TECHNICAL SPECIFICATIONS
Voltage 230V
Frequency 50Hz
Power 600W
Speed 16.000t/min
Planing width 82mm
Max. planing depth 2mm
Weight 2,7kg
Level of sound pressure measured according
to EN-standard:
Lpa (Sound pressure)
88 dB(A)
k= 3dB(A)
Lwa (Acoustic power) 101 dB(A)
k= 3dB(A)
Weighted root mean square acceleration
value according to EN-standard:
4,5 m/s² k= 3dB(A)
WARANTY
Refer to the enclosed warranty conditions for
the terms and conditions of warranty.
ENVIRONMENT
Should your machine need replacement after
extended use, do not put it in the domestic
waste but dispose of it in an environmentally
safe way.