Figure1.
Figure 1
b. Place nozzle in position over three studs on unit.
c. Secure with wing nuts just removed.
Attaching the handle
a
Remove the 4 screws fixed on both sides of the handle
，
turn the
handles 180 degree backward. See Figure 2.
Figure 2
a.
Make sure the opening under the handle is just toward to the small
opening on the round tube, then fixed with bolt.
b.
Take good care of the throttle line and switch line when adjust the
handle, do not broken them, then fix the throttle line and the
switch line on the handle, make sure they perform the best work.
Attaching the Chipping Chute
a. Place the chipper chute over the weld studs keeping the slotted
side towards the bottom. Loosely secure with the three hex nuts
and washers that were removed easily. Do not fully tighten the hex
nuts at this point in the assembly.
b. Align the support bracket with the holes in the right side of the
upper and lower handles. Put the chipping chute on.
