b.
Check bolts and screws for proper tightness at frequent intervals to
keep the machine in safe working condition. Also, visually inspect
machine for any damage and repair, if needed.
c.
Before cleaning, repairing, or inspecting, stop the engine and make
certain the impeller and all moving parts have stopped. Disconnect
the spark plug wire and ground it against the engine to prevent
unintended starting.
d.
Do not change the engine governor settings or overspeed the
engine. The governor controls the maximum safe operating speed
of the engine.
e.
Maintain or replace safety and instruction labels, as necessary.
f.
Follow this manual for safe loading, unloading, transporting, and
storage of this machine.
g.
Never store the machine or fuel container inside where there is an
open flame, spark or pilot light such as a water heater, furnace,
clothes dryer, etc.
h.
If the fuel tank has to be drained, do this outdoors.
y.
Observe proper disposal laws and regulations for gas, oil, etc. to
protect the environment.
Do not modify engine
To avoid serious injury or death, do not modify engine in any way.
Tampering with the governor setting can lead to a runway engine
and cause it to operate at unsafe speeds. Never tamper with
factory setting of engine governor.
Your responsibility
Restrict the use of this power machine to persons who read,
understand and follow the warnings and instructions in this manual
and on the machine.
Important
：
This unit is shipped without gasoline or oil in the engine. Be
certain to service
engine with gasoline and oil as instructed in the separate
engine manual before operating your machine.
VII. Loose Parts in the Carton
1. Following is the list of loose parts shipped with your equipment. Be
sure all of these parts are in the carton.
a. nozzle b. discharge tube c. bag d. side tube e. goggle f.
ear protector
g. bolts, nuts
（
if equipped
）
h . Wrench plug
NOTE
：
All references in this manual to the left or right side of the yard
vacuum is from the operating position only. Exceptions, if any, will
be specified.
Attaching the Nozzle
a. Remove three wing nuts from the front of the vacuum shredder .See
