36
7
Removing grinding tools
•
Place the grinding stone (16) on a flat surface, hold it in place and guide the sanding tool that you want to remove
in a straight line back and forth along the entire length of the grinding stone at the desired angle. Do not pass the
grinding tool over the edge of the sharpening stone. They will slide off.
When working on the rotating tool, do not only press on one point of the sharpening stone. This may pro-
duce a groove in the sharpening stone if repeated several times.
c)
Working with the flexible shaft
Install the tool required for your work into the collet chuck in the handle of the flexible shaft instead of directly in the
multi-purpose tool. You can then work with this extension. Working with the flexible shaft (17) allows you to reach
areas that are difficult to access. To use the flexible shaft when working, the multi-purpose tool must be suspended
from the supplied stand (18).
1
Inserting or replacing tools
To install, insert or replace tools on the flexible shaft (17), proceed as follows:
1. Turn the shaft slightly until the holes on the shaft and the handle are aligned with each other.
2. Insert the hex key (14) into the holes to lock the shaft.
3. Use the wrench (13) to loosen or tighten the collet chuck (on the handle).
4. Follow the steps below to mount, assemble or replace the tool. Refer to the instructions in section "a) Clamping
tools". Locking by means of the spindle lock is not necessary here. The hex key is used for this purpose.
Do not loosen or turn the shaft when unscrewing it before you have locked it in place. This may damage
the flexible shaft.
