This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in
electronic data processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited.
This publication represents the technical status at the time of printing.
Copyright 2016 by Conrad Electronic SE.
*1425137_v1_0416_02_IPL_m_en
Operation
• Place the product on a horizontal, flat, stable and sufficiently large surface (e.g. on a desk).
Protect valuable surfaces with suitable padding. Otherwise scratching, dents or
discoloration could be caused.
• Connect the power plug to a common household power outlet.
• Flip the lid upwards to open.
• Align the luminaire head as needed.
• Turn on the product (on/off switch to
I
position).
• Touch the touch-sensitive sensor surface to increase or reduce the LED brightness in
increments of 5 steps.
Increase brightness
Reduce brightness
• Turn off the product after use (on/off switch to
O
position) and flip the lid down.
Cleaning and care
a) General
• Disconnect the product from the mains supply before cleaning.
• Under no circumstances use aggressive cleanings agents, cleaning alcohol or other chemical
solutions since these can penetrate the housing or impair functionality.
• The product does not require any maintenance, do not disassemble it. Have maintenance or
repair services done by a specialist workshop only.
• Clean the product with a dry, fibre-free cloth.
• When cleaning, do not apply too much force on the lens or housing in order to avoid
scratching.
• The LEDs are built-in and cannot be replaced.
b) Lens
• Turn the bayonet catch anti-clockwise.
• Slightly press the lens from below to lift the bayonet catch.
• Remove the bayonet catch.
• Remove the lens.
• Use a lens cleaning cloth for cleaning the lens. Alternatively, use a dry, clean, soft and lint-free
cloth or a dust brush. If necessary, you can moisten the cloth with a little lukewarm water.
• When cleaning the lens with a cleaning agent, make sure not to directly apply the cleaner on
the lens. Always apply the cleaning agent directly to the cloth first.
• Replace the lens after cleaning. Turn the bayonet catch clockwise to secure the lens. The
catch must lock into place.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household
waste. At the end of its service life, dispose of the product in accordance with
applicable regulatory guidelines.
You thus fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
Operating voltage ......................... 220 – 240 V/AC, 50 Hz
Power consumption ...................... max. 5 W
Illuminant ...................................... 48 x SMD LED
Magnification factor ...................... 1.75x
Luminous flux ............................... 455 lm
Colour temperature ....................... 6500 K
Lens diameter ............................... approx. 102 mm
Cable length ................................. 130 cm
Operating conditions ..................... -5 to +40 ºC, max. 95 % RH
Storage conditions ........................ -20 to +60 °C, max. 95 % RH
Dimensions (L x W x H) ................ 180 x 176 x 350 mm
Weight .......................................... 1.38 kg
