TonerRefillKits.com
RechargX™ RX077 v2
Mon - Fri 8am - 5pm ET © 1995-2011 ReChargX™, EmptyX, TonerRefillKits and TonerRefillKits.com, the TonerRefillKits logo, the
2012.01.10
800.527.3712 or 352.343.7533 ReChargX™ and EmptyX logos are trademarks owned by TonerRefillkits, LLC. All rights reserved.
Page 6 of 7
Step 11: Empty the Waste Toner Hopper
Now we will remove the waste toner from the
toner cartridge.
NOTE:
This toner cannot be used again as
paper dust, hair, staples and other small
items can accumulate in the waste hopper.
Holding the cartridge over the newsprint,
included in the refill kit, carefully pour out
any waste toner, as shown in figure 12.
If the waste toner stops flowing, stand the
cartridge up again and then re-lower the hole
over the paper (gently tapping along the side
of the toner cartridge helps to keep the toner
flowing as well).
NOTE:
There is no need to attempt to remove
every last bit of waste toner from the hopper,
just that which comes out easily.
Step 12: Remove the Excess Plastic From
the Hole-Making Tool
Using the tip of the flat-blade screwdriver,
included in the ReChargX™ Tool Kit, remove the
small piece of plastic from the copper tip of the
hole-making tool, as shown in figure 13.
This small piece of plastic becomes impossible
to remove once it becomes cold and hardens to
the copper tip of the hole-making tool.
Figure 12
: Empty the waste toner hopper
Figure 13
: Remove the excess plastic piece
