Version 1.1
Copyright by
CYTECH 2006
ENG 5
www.indoorcycling.com
Due to the weight of the indoor cycle, it is recommended that two persons perform the
assembly. Set the studio cycle in a cleared area and remove all packing materials; do not dispose
of the packing materials until assembly is completed.
1. Identify the Rear Stabilizer (02 11 02).
Orient the Rear Stabilizer so the widest
parts of the Stabilizer End caps (02 11 06)
are at the rear.
While a second person lifts the rear of the
Frame, attach the Rear Stabilizer to the
Frame with two M10 x 60mm Bolts, four
M10 Washers, a Stabilizer Gasket (02 11 E
), two Plastic Washers (A), and two M10
Cap Nuts as shown (Stabilizer mounting kit
02 11 B).
2. Orient the Front Stabilizer (02 11 01) so
the widest parts of the Stabilizer End caps
are at the front.
While a second person lifts the front of the
Frame, attach the Front Stabilizer to the
Frame with two M10 x 60mm Bolts, four
M10 Washers, a Stabilizer Gasket ( 02 11 E
), two Plastic Washers (A), and two M10
Cap Nuts (Stabilizer mounting kit 02 11 B).
It is important that the plastic washers
(A) used on front and rear stabilisers
are mounted in the correct manner,
please also refer to page 24.
1
To avoid damaging the Front Stabilizer,
do not over tighten the Cap Nuts.
2
To avoid damaging the Rear Stabilizer, do
not over tighten the Cap Nuts.
A
M10 X 60mm Bolts
HOW TO ASSEMBLE THE INDOOR CYCLE
USER’S MANUAL – S/X-SERIES
02 11 E
A
