14
ENGLISH
ASSEMBLY THE WING
Pay attention to a proper cable guide. Stash
the excessive length of the leads away in
the wing by surrounding with foam to avoid
nasty noises.
14
Connect the aileron rods to the rudder- and
servo horns (outer servo). Make sure that
the rudder is placed in neutral position du
-
ring right-angled position of the servohorn. If
needed, adjust the rods.
The linkage of the flaps is realized by a cross
-
over connection through the surface of the
wing. Therefore the rod must initially be con
-
nected to the bottom side of the flap servo
and routed through the upper side of the
wing in order to be connected with the flap`s
rudder horn. If the servo horn is positioned
in a right-angle (neutral position), the deflec
-
tion of the flap should read approximately
15mm downwards.
12
Hint: A mechanically well adjusted model is
quite important. Therefore make sure that
you take your time, adjusting your model.
15
ARF: Install the servo in the servo opening.
We recommend the use of a designated
servo frame. Use a wire to route the servo
-
cable through the servo openings. The green
6-pole MPX plugsystem is used to connect
the fuselage.
13
After all electrical adjustments are finished and the rods are finely adjusted; use UHU-Por to glue
the servo opening covers and rod covers.
16
