Checking and Filling Fuel
OPERATING INSTRUCTIONS
16
WARNING!
TO PREVENT SERIOUS INJURY FROM FIRE:
Fill the fuel tank in a well-ventilated area away from ignition sources. If the engine is hot from use, shut the
engine
Off and wait for it to cool before adding fuel. Do not smoke.
1. Clean the fuel cap and the area around it.
2. Unscrew and remove the fuel cap.
3. Remove the strainer and remove any dirt and debris. Then replace the strainer.
NOTE:
Do not use gasoline containing more than 10% ethanol (E10). Do not use E85 ethanol. Add fuel
stabilizer to the gasoline or the Warranty is VOID.
NOTE:
do not use gasoline that has been stored in a metal fuel container or a dirty fuel container. It can cause
Particles to enter the carburetor, affecting engine performance and/or causing damage.
4. If needed, fill the fuel tank to about 1 inch under the fill neck of the fuel tank with 87 octane or higher
unleaded gasoline that has been treated with a fuel stabilizer additive. Follow fuel stabilizer
manufacturer’s recommendations for use.
5. Then replace the fuel cap.
6. Wipe up any spilled fuel and allow excess to evaporate before starting engine. To prevent fire, do not start
the engine while the smell of fuel hangs in the air.
Engine Oil Change
CAUTION:
oil is very hot during operation and can cause burns. Wait for engine to cool before changing oil.
1. Make sure the engine is stopped and is level.
2. Close vent on gas cap.
3. Remove the access panel on the right side of the generator.
4. Clean the top of the oil fill plug and the area around it. Remove the oil fill plug, turning it counterclockwise.
5. Place the generator on stands with the oil fill centered over an oil drain pan. Tilt the generator over the oil
drain pan and wait for oil to drain completely. Recycle used oil.
6. Set the generator back down on a level surface. Add the appropriate type of oil until the oil level is at the
proper level. Sae 10w-30 oil is recommended for general use.
7. Check the oil level. The oil level should be up to the edge of the hole as shown.
8. Thread the oil fill plug back in clockwise and replace the access panel.
full level
Summary of Contents for 79986
Page 23: ......
