13 (20)
Central Unit: (art. no. 2220052)
Installed in a suitable place in the area around the water unit. Check so that no
electrical cables or installations are found within 50 cm of the equipment, as this
disturbs the radio transmission. The box on the bottom has two “buttons” used to
open it. The back piece is attached to the wall with screws. Cable to the water unit
and the DC adapter is connected and the electronic unit is put back in place.
The DC adapter that comes with the product must be used for power supply.
First start-up
Connect the DC adapter of the central unit to a 230vac socket. Press ON to turn on the water, check
that normal water flow is possible. Inspect all new joints for minor leaks. In the menu system, press
the downwards arrow once to show the current water pressure. Then turn off the water main, the
pressure senso should now show the water pressure in the whole closed tap water system. Any
pressure drop that occurs at this point is due to a leak in the property’s water system. If the pressure
drops by more than 0.1 bar (measurement inaccuracy) in 15 minutes, troubleshoot the water system
to identify the leak and fix it. The open the water main for normal operation.
Remote Unit: (art. no. 2220022)
Place in an easily accessible place near an outer door. Check so that no electrical cables
or installations are found within 50 cm of the equipment, as this disturbs the radio
transmission. The box on the bottom has two “buttons” used to open it. Install two new
AA batteries in the battery compartment according to instruction. The back piece is
attached to the wall with screws and the electronic unit is put back in place.
Water sensor: (art. no. 2220042)
The sensors that come with the product are placed in the location
intended to be protected. For example by the dishwasher and sink: One
sensor underneath the dishwasher, one sensor on the floor underneath
the sink and the final sensor in the shaft where the pipes emerge from
the floor or in the door threshold.
For additional placement suggestions, see section 1.2.
Check so that no electrical cables or installations are found within 50 cm
of the equipment, as this disturbs the radio transmission. The box on the
bottom has two “buttons” used to open it. Install two new AA batteries
in the battery compartment according to instruction. The back piece is attached to the wall with
screws and the electronic unit installed in a suitable location.
(The wireless units packaged with the central unit are pre-programmed to communicate together
and do not need to be installed according to the instructions below.)
“Buttons”
“Button”
