Toledo Transducers MoniTTor N269, Installation And Operation Manual

Page: 17 / 53

10
N269 OPERATORS GUIDE
TURN ON POWER - The first time power is applied all values are set to 0.0 except for the
following:
CAPACITY = 100.0 each chan
THRESHOLD = 6.3 chan 0
HIGH SETPOINT = 100.0 each chan DIFFERENCE SET = 100.0 chan 0
LOWEST LOAD = 100.0 each chan
COUNT HIGH SET = 100.0 chan 0
OPERATING MODE = PEAK mode PRESET COUNTERS = 1
ENTERING DECIMAL POINT and CAPACITY (Only necessary at 1st power-up)
Press
HIGH HIGH HIGH pt. (0-3) ENTER (0-2) (value) ENTER
CHECKING CALIBRATION NUMBERS - (Sensor or cell must be connected)
1. press
TRACK (Track LED comes on, peak LED goes off)
2. Zero each channel (0,1,2) by adjusting BALANCE pot (chans. 1,2)
3. press
SHUNT (S appears in ch. 0, cal nos. appear in chans. 0-2)
4. Adjust GAIN pot chs. 1&2 to get proper cal nos. if not correct.
If the number will not go high enough switch to HIGH GAIN.
5. press
SHUNT (S gone, ch. 0-2 = 0. If not=0, repeat steps 2-5)
OPERATING MODES - press PEAK (Peak LED comes on, track LED goes off)
SETUP MODE - press SETUP - LED toggles on/off - if on, in SETUP mode
REVERSE MODE - press REV - LED toggles on/off - if on, in REVERSE mode
AVERAGE TONNAGE DISPLAY - press LOW COUNT 0 or 1 ENTER
0 = no averaging, 1= average of 16 hits (L displayed in chan 0)
IME MODES - press TIME TIME - LED toggles on/off - LED on=TIME mode
to change the TIME mode press TIME (0-3) ENTER
0 = B4, 1 = FIRST LEVEL, 2 = SECOND LEVEL, 3 = POINT-IN-TIME
SETPOINT DATA To display press: To change press:
HIGH SETPOINTS RESET HIGH CHAN # (value) ENTER
LOW SETPOINTS RESET LOW CHAN # (value) ENTER
TIME VALUE RESET TIME 0 (value) ENTER
BATCH COUNTER RESET PRECOUNT (value) ENTER
THRESHOLD LOW LOW LOW 0 (value) ENTER
COUNT HI SETPOINT HIGH COUNT 0 (value) ENTER
COUNT LO SETPOINT LOW COUNT 0 (value) ENTER
COUNT & TIME DATA To display press:
COUNT RESET COUNT
HI COUNTS COUNT HIGH
LO COUNTS COUNT LOW
RATE in SPM COUNT TIME
DOWNTIME TIME COUNT
TONNAGE DATA To display press:
LAST ALARM HIGH LOW
LAST HI ALARM HIGH TIME
LAST LO ALARM LOW TIME
HIGHEST LOAD RESET HIGH HIGH
LOWEST LOAD RESET LOW LOW
RELAY TIMERS To display press: To change press: