15
CHANGING THE HANDLE FOR RIGHT/LEFT HAND USE
1. Remove the hoist from its hanging position and dis-connect the air supply. Push the
operating buttons to confirm that the hoist does not operate.
2. Remove the M5 14 Hex screws which hold the handle in place. Make sure the
springs do not spring from under the handle when the hex screws are removed.
3. Remove the Hose nipple and Hex taper plug ( 3/8
−
18) from the handle.
4. As shown in the diagram bellow, situate the handle for Left or Right hand usage.
5. Re-assemble the Hose nipple and Hex taper plug ( 3/8
−
18 ) as instructed in section 3
above. Assemble the handle onto the hoist.
6. Assemble the 4
−
Hex screws ( M5 14) in section 2 into the handle and onto the hoist.
At this time do not forget to assemble the springs. Also remove any dirt from the
packing and align the 4 holes in the handle with the hoist.
7. Apply air to the hoist and check for air leakage.
8. Hang the hoist in position and slowly check the Up and Down movement of the hoist.
The handle on this hoist can be changed to suit right handed or left handed operators. In
order to make the change, follow the following instructions to make the change in the
handle.
△
！
CAUTION ;
When removing and changing the handle, please be assured not to allow
dust, dirt or foreign matter enter the hoist.
Procedure of making the change in the handle
Air & Allied Sales (Pacific) Pty Ltd
www.air-allied.com.au