PRECAUTIONS / Heat Consideration
Xenon lamps produce heat and will cause damage if they come in direct contact with persons or combustible
materials. In accordance with NEC/NFPA 70 Article 410.11, combustible materials next to fixtures must not be
subjected to temperatures in excess of 90º C (194º F). In order to conform to this standard, fixtures need to be
installed according to the minimum space requirements shown below.
Step 1: Mounting Fixtures
Option 1 - Direct Screw Mounting (Part# AV-MS)
Each LED or lamp socket, has four mounting holes designed to accept
screws. For secure mounting, use two screws in opposing holes. Sockets
must be firmly attached to support the weight of the fixture.
Option 2A - Channel Clamps (Part# AV-CL)
These clamps are for use with our AV-MC Mounting Channel. Screw the
clamps securely in place, then snap in the channel. Attach clamps every 8".
Option 2 - Mounting Channel (Part# AV-MC)
An optional mounting channel may have been provided with your
materials. Screw the channel securely in place, then snap each socket
into the channel. Attach screws every 8".
End Caps - Part# ECD-WH (White) / Part# ECD-BK (Black)
Ends caps are attached to the end of each Advantage lighting fixture. If the
fixture needs to be trimmed, a new end cap needs to be attached to the end
of the fixture after trimming.
3", 4" and 6" socket spacing
Seamless Light
Advantage fixtures are flexible enough to turn
corners without the use of special hardware,
eliminating dark spots at corner locations.
2.4" socket spacing
Channel Clamp
Mounting Channel
conforms to a 24" inside
or outside radius.
With Reflector 2.4" O.C.
Watts
d1
d2
D
3
5
.75"
.75"
.75"
1.25"
1.5"
2"
Basic System 2.4" O.C.
Watts
d1
d2
D
3
5
1"
1.5"
.75"
1"
1.75"
2.5"
Basic System 2.4" O.C.
Watts
d
D
3
5
1"
1.5"
2"
3"
Basic System 2.4" O.C.
Watts
d
D
3
5
.75"
1"
1.5"
2"
D
D
D
D
d1
d2
d1
d
d
d2
d
d
Attach screws
every 8"
End Cap
Advantage Instructions
Page 2
