8
fig. 4
ASSEMBLANCE OF THE STRAP
The modules have to be assembled in pairs, and have to be united between
them by a strap. You have to screw the strap to the end of the piece (4) using
the 5mm x 15mm screws and 6mm nuts (10), fig.8.
Take into account that the strap has to be attached to the lower part of the
profile (4), fig.9. in a way that the heads of the screws are in the upper side of
the profile and the nuts are in the lower side of the profile.
fig. 8
fig. 9
ASSEMBLANCE SRAIGHT AREA
After having assembled all of the modules, and after having connected them
with the strap you can now put them in their final location.
If your swimming pool has an odd number of straps (eg, a 730x366 pool with 3
straps) search for the centre of the previously leveled area and situate there
the first module, then situate the others at the same length.
Always keep the same number of modules at each side of the swimming pool
fig. 10 and fig. 11.
It is extremely important that all of the modules are straight, leveled and
perfectly lined up. Take your time to ensure that they are situated correctly.
ASSEMBLANCE OF THE METALIC GUIDES
The following step would be to insert the
transitional guide “B”, that
corresponds to the swimming pool model you have acquired (see the
transitional guide table) at both sides of the first module (take into account that
the oval model 550x366 has NO trans
itional guides “B”). This transitional guide
has to be situated inside the guide rail connector (6), fig. 12.
Situate the transitional guide in the guide rail connector (6), fig. 13, at each side
of the pool. Then continue to assemble the transitional
guides “A”.
fig. 10
fig. 11
fig. 5
fig. 6
fig. 7