14
foto 10
foto 11 foto 12 foto 13
INSTALLATION OF THE UPPER PROTECTIVE SECTION (PL)
e) Remove the clamps while installing the protective profile (PL), fig. 24, over the liner and around the perimeter of the
pool.
f) Mark and cut off the protector surplus, photos 15 and 16
INSTALLATION OF THE UPPER SECTION (PBS)
Important:
If your pool has included the decorated band, place it as per the decoration’s manual, before installing the upper profiles
PBS.
g) Position the upper section (PBS) on top of the protective section (PL) around the entire pool perimeter, photo 17.
h) Mark and cut off the protector surplus, photos 18 and 19. To prevent the pool wall from falling inwards, place the upper plat e (5)
on the central columns (1).
foto
17
foto 18
foto 19
ASSEMBLY OF THE VERTICAL SECTIONS (VER)
a. Align the lower part of one of the vertical sections (VER) (1) with the two small tabs on the base plates (T1) (2). The
tabs must be on the inside of the vertical section, fig. 26.
b. Align the openings for positioning screws TO2 (3), on either side of the vertical section, making sure that they attach
to the holes in the T1 (2) plate tabs, fig. 26.
c. Place an upper section (T2) (4) onto the top edge of the pool and on a vertical column (VER), with the tabs on the
inside of the section, fig. 27.
d. Align the openings for positioning screws TO2 (6), fig. 27, in the three holes in the vertical section, making sure they
fit into the T2 (6) tab holes.
e. Repeat steps a, b, c, d in the other sections around the pool.
foto 14
foto 15
foto 16
