TOHATSU MFS 6BZ, Owner'S Manual

Page: 25 / 88

INSTALLATION
25
5
1. Bolt (8 × 85)
2. Washer
3. Nut
ENOW00008-A
z Upper mounting bolts should be installed
with the bolt head at inside surface of the
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
z
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-1
Notes
1. Apply sealing agent, such as silicone
sealed between the bolts and the
transom board holes before tighten-
ing the bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
3. For EP / EFT type, drill the holes in
transom board only at left and right of
lower side of clamp bracket, and
attach outboard motor with supplied
bolts.
For EPT type, drill the holes in transom
board at 4 points up and down, right
and left, and attach outboard motor
with supplied bolts.
ENOM00840-0
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
Install the remote control box in a posi-
tion where it is easy to reach and oper-
ate the controls.
CAUTION
3
1
2
ENOF00507-1
ENOF00508-0
2. Remote control device
installation
3
1, 2
ENOF00841-1