TOHATSU M 15D2, Owner'S Manual

Page: 29 / 76

PRE-OPERATING PREPARATIONS
29
6
]ENOM00033-A
Your new outboard motor and lower unit
require break-in for the moving compo-
n e nts a c c ording to the c on ditions
described in the following time table.
Please refer to ENGINE OPERATION sec-
tion (See page 30) to learn how to cor-
rectly start and operate the outboard
motor.
ENOW00024-A
Do not operate the outboard motor in
closed area or area with no forced ventila-
tion.
Exhaust gas emitted by this outboard motor
contains carbon monoxide that will cause
death if inhaled continuously. Inhaling the
gas initially causes symptoms such as feeling
of sickness, drowsiness and headache.
During operation of the outboard motor:
z
Keep peripheral area well ventilated.
z
Always attempt to stay on the windward
side of emission.
ENOW00023-0
Operating the outboard motor without
break-in can shor ten ser vice life of the
product.
If any abnormality is experienced during the
break-in:
z Discontinue the operation immediately.
z Have the dealer check the product and
take proper action(s) if necessary.
ENOM01004-0
Fuel mix ratio for break-in
Gasoline 25: Genuine Engine Oil 1
25:1 when using genuine engine oil or the
recommended one (TCW3).
ENON00008-0
Note
Proper break-in allows outboard motor to
deliver it full performance for longer ser-
vice life.
4. Break-In
WARNING
CAUTION
1–10 min 10 min – 2 hrs 2–3 hrs 3–10 hrs After 10 hrs
Throttle Position Idle
Less than 1/2
throttle
Less than 3/4
throttle
3/4 throttle
Full throttle
available
Speed
Approx. 3000
min
-1
(rpm) max
Full throttle run
allowed for 1
min every 10
min
Approx. 4000
min
-1
(rpm). Full
throttle run
allowed for 2
min every 10
min