69
SERVICING YOUR OUTBOARD MOTOR
4. Disconnect the wire connector
from the ignition coil by pushing
on the lock tab and pulling on the
connector. Pull on the plastic
connector, not the wires.
5. Use a 10 mm wrench to remove the
bolt holding the ignition coil.
Remove the ignition coil by pulling
it up slightly.
Do not strike or drop the ignition coil,
or it may be damaged and require
replacement.
6. Remove the spark plugs with a
spark plug wrench and 19 mm eye
wrench.
7. Inspect the spark plugs. Replace
them if the electrodes are worn, or
if the insulators are cracked or
chipped.
8. Measure the spark plug electrode
gap with a wire-type feeler gauge.
The gap should be 0.039 – 0.051
inches (1.0 – 1.3 mm). If the gap is
out of the specification, replace the
plug with a new one. Never try to
readjust the gap.
BOLT
IGNITION COIL
WIRE CONNECTOR
LOCK TAB
SPARK PLUG
WRENCH
19 mm EYE
WRENCH
0.039 – 0.051 in
(1.0 – 1.3 mm)
SEALING
WASHER
INSULATOR
31ZY2T000.book 69 ページ ２０１３年１０月１６日 水曜日 午前１１時４０分
Summary of Contents for BFT200A
Page 124: ...122 MEMO 31ZY2T000 book 122...
Page 125: ...123 MEMO 31ZY2T000 book 123...
Page 126: ...124 MEMO 31ZY2T000 book 124...
