x
y
2.
3.
5.
Nut
4.
hinge
Changing the batteries:
More information about how to change batteries is on the back of the supplied remote control
unit.
Battery: CR2032 (1 item)
Mounting the Base
optional
Place the shaft of the lumianire on a flat surface - protecting against scratches - and assemble the foot and
the head of the luminaire.
1. Connect both foot sections together by the hinge.
2. With your thumb, press the plastic plate directly onto foot sections at the bottom of the shaft (see diagram).
The foot sections will automatically move into the correct position, enclosing
the shaft of the lumiaire without scratching it.
3. Push the connectiing cable in the direction of arrow (see dia-
gram) until a loop is formed.
4. Before inserting the clamps, see that both sides have the
same length of thread (x=y), otherwise it is not possible for
the foot to embrace the shaft. Apply the correct amount of
tension: turn part with groove to the left!
5. After employing the clamp, pull the cable down so that
the clamp does not slip while rotating. The clamp will
tighten. Use an allen key to rotate the chuck
axis. Insert the key into one of the two holes
and push down. Move onto the second
hole and do the same. Repeat this
porocedure until the foot sections
are securely connected to the
shaft.
08
22
Summary of Contents for XA20-0
Page 2: ......
